Skip to content
RigBench

Headphone and Speaker Test

Turn your system volume down, then play each tone. Check the left and right channels, the phase test and the bass sweep at a safe level.

Runs locally in your browser. No data leaves your device.

Now playing
–
Volume30%

Starts at 30%. Turn your system volume down before raising it.

Ready

What to listen for

Left only should play in your left ear and Right only in your right. Center should sound like it comes from inside your head or between the speakers. If In phase sounds hollow and Out of phase sounds full, one speaker is wired backwards.

Try this first (free)

  1. Left and right swapped: check the headphones are not on backwards (look for the L and R marks), then check Sound settings for a balance slider and any virtual surround software.
  2. One side quiet or silent: wiggle the cable at both ends while the tone plays. Crackling or dropouts point to a damaged cable or plug, not the driver.
  3. Rattle during the bass sweep: note the frequency on screen, then press on desk items, the monitor stand and speaker grilles at that frequency to find the source.
  4. No bass at all below about 80 Hz on laptop speakers is normal. On headphones it usually means a poor seal: try larger ear tips or adjust the ear cups.

How to read the results

Every tone is generated in your browser with the Web Audio API, so nothing is streamed or downloaded. Each test plays once; press it again to stop early.

What each test checks

  • Left only and Right only: channel order and that both drivers work.
  • Center: both channels balanced. The tone should sit in the middle.
  • In phase and Out of phase: speaker wiring polarity.
  • Stereo pan sweep: smooth left to right movement with no dead spots.
  • Sub-bass sweep: low frequency response and rattles.

Setting up for calls? Check your microphone with the mic test.

Questions

How do I test left and right on my headphones?

Turn your system volume down, then press Left only. You should hear the tone only in your left ear. Then press Right only. If the sides are reversed, check the L and R marks on the headphones first, then your system's balance settings and any virtual surround software.

What is the out of phase test for?

If the in phase tone sounds hollow and the out of phase tone sounds solid, one speaker is wired backwards (red and black swapped). Fixing the wiring restores bass and a clear center image. On headphones it can point to a faulty cable.

What does the bass sweep test?

It plays a smooth tone from 20 Hz to 200 Hz over 12 seconds. Use it to hear where your headphones or speakers start producing bass, and to find rattles in desks, monitor stands and speaker cabinets, usually between 40 and 120 Hz.

Is the test volume safe?

It starts at 30% of the browser's output, which is quiet on most systems. Still, turn your system volume down before playing anything and raise it slowly. Low bass tones can be felt more than heard, so do not raise the volume to hear the lowest notes.

Why can't I hear the lowest part of the bass sweep?

Small laptop speakers and many earbuds cannot reproduce frequencies below about 80 to 100 Hz, so silence at the start is normal. On over-ear headphones, a poor seal around the ear is the most common reason bass disappears.